Ever tried to cut PVC pipe straight with a hacksaw? It’s not easy and it’s not fun. There are better tools that can make the job easier and faster, but many people use hack saws because they already own them and don’t want to go out and buy something else.
How to cut pvc pipe straight with hacksaw
Follow these steps to cut PVC pipe more precisely and quickly with a hacksaw.
Cutting PVC Pipe Summary
PVC pipe is surprisingly easy to cut straight with a hacksaw. All you need is some patience, and the right technique.
First, draw your line on the pipe where you want it cut. Next, clamp the pipe down on your saw’s table at that point using either T-clamps or C-clamps (whichever are available). Then start cutting slowly.
You’ll know when you’re finished because the blade will stop cutting and make a light plink sound as it bounces off of the inside of the cut pipe.
And finally, use sandpaper or electric sander to round out any sharp edges so that they are safer for handling and fitting together. Here is Guide about How To Cut A PVC Pipe With Sawzall
Cutting tools can be dangerous.
Hacksaws are one of the most popular cutting tools, which is why we’re going to talk about how to cut pvc pipe straight with hacksaw. The first thing you want to do is lay your pipe on a flat surface and measure how long it should be.
Make sure you don’t forget this step! Then take your hacksaw and tighten it so that the blade is facing down. Hold it at the end of your pipe so that you’re cutting vertically through the center of it.
PVC Cutting Tools Explained
A hacksaw is the only tool you need for cutting pipe. There are two types of saws: a handsaw and an electric saw.
The handsaw is the less expensive option, but it requires more physical labor than an electric saw. An electric saw will cut through any size of pipe faster and more accurately than a hand saw, but it is also more expensive.
To use either type of saw, line up the blade with the centerline of the pipe as closely as possible and start cutting from one end to the other in long strokes at about 3⁄4 of an inch deep.
Make sure your blade is sharp so it will make smoother cuts without chipping out any material on either side of the line
Hacksaw / Back Saw Cutting Steps
- Mark the cut line on the pipe using a marker or pencil.
- Apply masking tape along both sides of the line about three inches from the end of the pipe. This will help prevent any cuts from extending past your marked line and will also provide a good surface for holding onto the pipe when sawing.
- Carefully align your hacksaw blade over one of your marks and apply pressure to make an initial deep cut into the pipe.
Try to keep your saw blade flush with the top of the pipe, perpendicular to it, as you cut. Once you’ve made this first cut, move down and do another until you have completely severed that side of the pipe in two pieces.
Keep applying pressure as you go and try not to saw too quickly because this could cause friction between the two halves which would result in them being glued together rather than separated by your saw.
To prevent accidents, be sure that all children are away from where you are working before proceeding with cutting out each piece individually. Here is Pickbeast